|
Post by james on Dec 14, 2011 19:39:26 GMT -5
I made these for a guy that sent me some file. Cleaned the rust off them and looked at the name on the files.And do not find any file brand that I use. So I heated a round file up and squred it up and angler grind up the flats enges and made two strikers out of it. Set them aside and grabbed a flat file and started another to strikers. I normlized two and then quanched them in brine. Cleaned them up and tested them up to make shure they work. Did this last week when it was cloudy and cold . The two on the ends are the flat file the two in the middle are is the round file. I used this site as a referance , and made mine as close as i can . www.angelfire.com/journal2/firefromsteel/
|
|
|
Post by whitedove on Dec 14, 2011 21:27:44 GMT -5
very nice.. WhiteDove
|
|
|
Post by paweaver on Dec 16, 2011 8:34:39 GMT -5
Cool! I have to admit I loved the video. Getting sparks is always fun, but getting some from something you made must take it to the next level of pleasure.
paweaver
|
|
|
Post by james on Dec 16, 2011 11:46:40 GMT -5
Thanks you both.
|
|